Trusted appliance repair in Little Elm

Gregorio M.

Ge cooktop Back 2 burners not igniting properly looked at the cooktop and determined that the caps where on the wrong side so I switched them back now it is working fine.

Jimmy C.

Kenmore elite front load washer- washer is tripping breaker whenever you power it on. Electrician came out and did something to the breaker and said to call us out just to make sure the washer is fine. The washer did not trip for me during my diagnostic testing. From what I can tell, none of the components seem to be having troubles. The only thing I did notice is there is brown water stains on the inside of the washer by the bearings. That indicates the bearings are leaking water due to the bearing seal wearing out. Usually when that happens, there is a noise indication during the spin cycle but during the spin cycle test the washer sounded normal. Those water stains could be from a previous repair in the past, but the customer does not recall of any repairs involving the bearings. Keep an eye on the washer. If the issue persist, I would say the next step is to replace the bearings and the associated hardware along with the drive motor.

Gregorio M.

Whirlpool Refrigerator no water or ice being made. Looked at the refrigerator and determined that the water valve needed to be replaced. As well as LED light in freezer, told home owner and they agreed to the repair.

Deimy G.

I was called to a home to repair a noisy Lg freezer. Upon inspection, I found that the ice maker fan was frozen. I cleared the ice and tested the components, and the unit is now running smoothly and quietly.

Jimmy C.

Samsung dryer no heat- I opened up the dryer and found that the heating element coil had a break in it. Replaced heating element and now the dryer is working as intended.

Gregorio M.

lg range and determined that the front right burner infinite switch needs to be replaced so homeowner had me replace it.

Jimmy C.

LG Washer issue- washer is leaking even when not in use. I opened the water inlet valve access panel and found that the valve had a crack in it allowing water to shoot out. I replaced the water inlet valve and now the washer is no longer leaking.

Jimmy C.

Washer issue- washer is starting a cycle but not filling with water. Customer informed me she had some plumbing work done before the issue happened. I found that the washer water supply valves on the wall were turned off. I turned them back on and now the washer is filling with water. Ran a calibration cycle and everything went through as intended.

Jimmy C.

Washer issue- washer is sounding louder during the spin and is not spinning the water out of the clothes as well anymore. I determined that the transmission is leaking oil onto the drive pulley and belt and causing it to slip during its spin cycle. We will need to replace a transmission to fix the issue. Customer has declined to repair.

Skyler K.

My name is Skyler with action appliance.. I’m over here at Mr. Simon’s house this gentleman had a loud squeak coming from his dryer. I found that the bearing was bad on the dryer.

Gregorio M.

Kitchenaid Refrigerator ice maker not working looked at the refrigerator and determined that the ice maker needed to be replaced

John N.

Customer complained unit not cooling. Sealed system issues we has to changed out the compressor and also flushed out the sealed system lines. Checked out unit all ok

John N.

Whirlpool refrigerator, not cooling at all. Diagnosed found unit has a sealed system issues. Refrigerant on this unit is R600 A. Which is flammable refrigerant.

Deimy G.

Samsung refrigerator not dispensing water and ice. Determined user interface is causing the issue. Replaced part with one provided from customer .

Deimy G.

LG Compresor replacement due to not cooling.Unit was flushed nitrogen and controlled board was undated and filter dryer was replaced.

John N.

Wine cooler not working properly. Improper setting.

Deimy G.